News-Qingdao Brighten Co., Ltd

how to how to trim a candle wick properly

05 November 2026

  • Share to

Do this step

Wait until the wax is fully solid, then pinch off the black tip with your fingers or a tissue. Aim for 5 mm of bare wick above the wax. Throw the clipping in the bin; a bit of wick left in the pool will smoke later. Two seconds of trimming saves roughly 30 minutes of burn life per light. Anyone searching "how to trim a candle wick properly" should note this: keep the trimmer on the same shelf as the candle, because a tool you can see is a tool you use.

Why trimming helps

The flame stays under 25 mm tall and burns blue at the base instead of orange. Less unburned carbon escapes, so you see almost no smoke and no black dust on the glass. Trimming also stops the wick from curling over into the melted wax. That is why it is the cheapest fix for a smoky candle.

Quick check before you light

Look at the wick from the side at eye level. If it leans more than 3 mm off center, nudge it straight with a toothpick while the wax is soft. A centered wick spreads heat evenly and keeps one side of the jar from running hot. A well-trimmed wick on a 180 g soy candle should give about 35 hours of total burn time.

Keep a small trimmer next to the candle and make it part of your routine. Brighten sizes each wick to the jar width and burn-tests the trimmed length, so the flame behaves the same on hour one and hour thirty.

How to Fix Candle Tunneling Without Wasting Half the Wax

Next

last page