News-Qingdao Brighten Co., Ltd

How to Fix Candle Tunneling Without Wasting Half the Wax

03 November 2026

  • Share to

How to Fix Candle Tunneling Without Wasting Half the Wax

Learning how to fix candle tunneling starts with one move: wrap foil around the jar rim and let the heat bounce back inward. This melts the hard wax ring left along the glass wall, usually within a single burn session.

Do this first

Cut a piece of aluminum foil and lay it loosely over the top of the jar. Leave a small opening in the middle so air still reaches the flame. Burn the candle for about two hours, then peel the foil off and check the surface. Keep the wick trimmed to 5 mm before you start, because a long wick pushes heat sideways instead of down. For "how to fix candle tunneling", one detail matters most: note how long the foil took to work, since that number becomes your ideal burn length from now on.

Why candle tunneling starts

Tunneling happens because the flame never threw enough heat to the outer edge. Foil traps warm air above the wax and raises the surface temperature by a few degrees. The ring softens, slides into the pool, and the candle relearns a wide burn. Most jars need only one foil session when the wick is the right size.

Quick check after cooling

Let the wax harden for at least four hours, then run a finger across the top. If the middle still sits 6 mm below the rim, a 200 g jar usually needs one more 90-minute foil burn to finish the job. Never pour melted wax out; that removes fragrance oil and shortens burn time by roughly a fifth.

Trim, foil, and give your next burn a clear two-hour window so the pool reaches the glass wall. Brighten matches every wick to its jar diameter and runs timed burn tests before packing, so our candles reach a full pool on the first try.

Candle E-commerce vs Retail: Growth Analysis

Next

last page